Contact Us

EPM, Inc.
112 W Burke St.
Stockbridge, GA 30281
800-659-5050
sales@epm.com

Phones and Fax Numbers

Call Free in the US: 800.659.5050
Local & International: 770.389.0501
Fax U.S: 888.353.7325
Fax Local & International: 770.389.0652
Special Type Oil Seal Lip Designs 2016-12-29T09:16:30+00:00

Special Type Oil Seal Lip Designs


Standard – Leather

Standard – Rubber
standard_lip The most popular design in our range of seals. A spring loaded element enclosed in a steel casing presents a robust seal.


ED1

ED1R
ed1_lip Two sealing members with opposed lips. One to exclude foreign matter the other to retain lubricant.


ED2

ED2R
ed2_lip Again dual elements designed for applications of a more critical nature.


ED3

ED3R
ed3_lip When duplicate sealing members are required, but the width does not allow ED1 to be used, then ED3 is an excellent alternative. The washer prevents dirt, etc. from damaging the main element.


ED4

ED4R
ed4_lip A further variation of dual sealing. Here the spring loaded element is preceded by a washer.


ED5

ED5R
ed5_lip From time to time arduous conditions require a special dual seal which will allow grease to be administered to the center cavity after the seal is installed, thereby cleaning the wiping lips of extraneous matter. Such is the make up of our ED5.


ED6

ED6R
ed6_lip Two seals fitted back to back, one with indentations, which again allows the easy passage of lubricant administered through a grease nipple.


ED7

ED7R
ed7_lip A dual seal with both lips facing each other, allowing a liberal quantity of grease to be prepacked before assembly. Particularly suitable when automatic grease feed is not possible.


EG1

EG1R
eg1_lip Where both axial and radial dimensions are restricted we offer a springless seal.


EG2

EG2R
eg2_lip Limited space requiring dual sealing poses a problem which is overcome by our EG2 type.


EG3

EG3R
eg3_lip A triple lipped springless seal is ideal for grease and thick oils.

Type EX (not illustrated) – The sealing element is mounted externally where the requirement is to seal the housing as opposed to sealing the shaft which is stationary, the housing revolving around the seal. Combinations of material are possible as are special designs to customer requirements.