Contact Us

EPM, Inc.
112 W Burke St.
Stockbridge, GA 30281
800-659-5050
[email protected]

Phones and Fax Numbers

Call Free in the US: 800.659.5050
Local & International: 770.389.0501
Fax U.S: 888.353.7325
Fax Local & International: 770.389.0652
Speed 2016-12-29T09:16:45+00:00

SPEED

It is very difficult to estimate the maximum speed of a dynamic seal, due to the many functions and factors involved, for example working pressure, fluid viscosity, surface finish, and the seal material resistance to abrasion. As shown in Figure S-1 the optimum sealing friction was experienced at speeds between 0.05 m/s to 0.15 m/s. for speeds lower than 0.05 m/s there is insufficient oil film between the sealing lip and the metal surface, thus allowing direct contact. This produces high friction, rapid wear and irregular stick slip movement. For speeds over 0.5 m/s hydrodynamic pressure occurs, which means the sealing lip is kept away from the metal surface causing fluid leakage.

The basis of fiction is calculated by using Newton’s law for laminar flow:

figure17


F = µ x dv/dh

F = friction force
µ = dynamic fluid viscosity
v = speed
h = fluid film thickness

Figure S-1 (At the beginning of motion and within certain values of velocity, hydrodynamic pressure forces occur, which means there is a constant lubricating film between the seal and the metal surface. Due to surface finish contours an increase in hydrodynamic pressure will occur maintaining the lubricating film.


Therefore friction is directly proportional to the working pressure. the higher the pressure, the more seal surface area is in contact with the metal surface, and consequently the higher the friction.
 

figure18

Figure S-2 (The continuous film of lubricant reduces the deformation force Fd and therefore produces a “leveling” effect on the metal surface.)

 

figure19

Figure S-3